Please note that we can not accept Visa Electron cards for payment

 

The ETana is a 44" wingspan aerobatic airplane. Its large control surfaces makes it 3D capable. The ETana was carefully engineered to eliminate coupling in knife edge allowing the less experienced pilot to knife edge with ease.

The ETana assembles quickly and easily. The laser cut kit is almost foolproof with interlocking pieces designed with AutoCAD. Much of the fuselage and wings are assembled before you start gluing. The wings plug into a carbon fiber spar and the tail surfaces are airfoiled for good control response. The landing gear is pre-bent 6061 T6 aluminum and the wheels and pushrods are included with the kit. Both a front firewall mount and a GWS style stick motor mount are provided. The mounts bolt onto the fuselage, allowng easy swapping.

The ETana is designed to fly with a brushless motor capable of 200 watts. The prototype has flown well on an Axi 2808-24 propped to pull 15 amps (150 watts) and has performed well. At these power levels, a 3S 2000mAH Lipoly battery pack is recommended

In addition to the kit, you will need two Naro Max BB for elevator and rudder, two Naro Std or Naro +F HP/BB for ailerons, two 6" servo extension cables, two 12" servo extension cables, and two rolls of Solite covering. If your transmitter does not have two aileron servo mixing, you will also need a Y lead.

418"sq

45"

200-250W

Around 24oz + batteries

2 x Naro Max BB
2 x Naro Std

sold out